WebSet IPMC Control Bits Use the following command to set the configuration of the blade server’s LED and the AMC shutdown behavior. Data Bytes Note - If an attempt is made to write 0 to any reserved bit (3 to 7), IPMC will reject the command with completion code 0xCC. Get IPMC Control Bits WebOct 21 15:51:15 stephen kernel: IPMI message handler: BMC returned incorrect response, expected netfn 7 cmd 35, got netfn 7 cmd 22 Oct 21 15:51:15 stephen kernel: IPMI message handler: BMC returned incorrect response, expected netfn 7 cmd 22, got netfn 7 cmd 35 After some bisecting, I found that the patch that causes this is a patch to reduce ...
ipmi - understanding ipmitool(1) watchdog - Server Fault
WebSince the update to the most recent version (in comparision to the packages from last december 2013) the following new messages appears Raw IPMI Watchdog: Unable to … WebIf you want to change the default behavior of the watchdog timer, or implement some of the other available features, you can configure the BMC. You use the Intelligent Platform Management Interface (IPMI) to configure the BMC. Commands that are sent over IPMI are independent of the appliance CPU, firmware, and operating system. how to stream ps5 on obs without capture card
Error: Unable to establish IPMI v2 / RMCP+ session
WebFollowing table is IPMI WDT command: ipmitool mc watchdog : Example: Get Current BMC's Watchdog setting # ipmitool mc watchdog get Watchdog timer setting Default ipmitool command doesn't have a parameter to set WDT timer, user may use following "raw" command to set BMC WDT timer Set BMC watchdog timer setting … Web[ 83.015337] IPMI Watchdog: response: Error ff on cmd 22 [ 83.324851] usb 1-1.2: device not accepting address 3, error -32 [ 83.391564] usb 1-1.2: reset full speed USB device … WebRe: [Openipmi-developer] ipmi_watchdog: IPMI Watchdog: response: Error 80 on cmd 22. From: cminyard - 2011-11-21 21:36:51 reading aloud examples